Sump Pump Check Valve

A sump pump check valve is an important part of a sump pump system that helps ensure water goes where you want it to. If your sump pump’s check valve fails, it can allow water to flow back into the sump pit, reducing the amount of water removed per cycle and causing increased energy costs.

The Sump Pump Check Valve

One of the most common problems with a sump pump is that it doesn’t have a check valve. This can cause water to flow in a different direction than it should, which could result in sewage backups or other damage to your home. You can test a sump pump’s check valve to determine whether it needs to be replaced by pouring a bucket of water into the pit and watching for leaks. If there is a significant amount of water leaking from the pump’s check valve, this is a sign that it needs to be replaced.

The Check Valve is the Most Costly Device in a Sump Pump System

A check valve is an essential component of a sump pump system because it prevents water from flowing back into the pit. It is also a valuable tool that allows the pump to shut off when it isn’t needed, thereby saving you money on electricity. There are a variety of types of check valves, so you’ll need to choose the right one for your pump system. You’ll need to consider the height of your drainage pipe, as well as the water pressure. The correct size will help ensure that your sump pump can move water against gravity and effectively remove excess water from the basement.

Spring Loaded Valves Are Quieter Than Gravity-Based Valves

If you’re looking for a better alternative to gravity-based check valves, you should try a spring loaded model. They are a lot quieter than their gravity-based counterparts because they don’t rely on the pressure of water to close. They can be noisy if they aren’t working correctly, so make sure you replace the valve when it’s time to. It’s worth replacing a faulty check valve, as it can save you a lot of money on your electrical bills and the potential for a serious flooding problem.

How to Replace a Sump Pump Check Valve

Installing a new check valve in a sump pump can be an easy process. The most important thing to remember is that you’ll need a replacement check valve that matches the diameter of your drainage pipe. This is typically either 1 1/4 to 1 1/2 inches in length. You’ll need PVC couplings and nuts to adapt the valve into your discharge pipe. To prepare for installation, first make sure your drain line is long enough to accommodate the new valve and fit it in place. If it’s too short, you’ll need to cut off some of the length with a hacksaw or pipe cutter. Then, use a pair of scissors to trim the new pipe down until it fits snugly in place. Once you’ve done that, connect the bottom pipe to the new check valve and do a dry run to make sure everything is working properly. If there are any issues with the fit, you can use PVC cement to fix it.